.: Advanced Linux Networking :.

If your local network has a DHCP server, you can configure Linux to obtain its IP address from this server automatically, by using a DHCP client. This client sends a broadcast message on its local network segment to search for a DHCP server. If a DHCP server responds, and if the ensuing negotiation is successful, the result should be a system with an IP address and associated information, fully configured to use the connection.



Most Linux distributions give you the option of using DHCP during installation. You should be able to select a DHCP option when configuring the network settings. If not, or if you need to reconfigure the computer after installation, the easiest way to enable this feature is usually to use a GUI configuration tool, such as Linuxconf (Red Hat or Mandrake), COAS (Caldera), or YaST or YaST2 (SuSE). For instance, Figure 2.1 shows the YaST2 configuration screen in which this option is set. Click Automatic Address Setup (via DHCP), and the system will obtain its IP address via DHCP.

Unfortunately, DHCP configuration isn't always quite this easy. Potential problems include the following:

• Incompatible DHCP clients— Four DHCP clients are common on Linux systems: pump, dhclient, dhcpxd, and dhcpcd (don't confuse either of the latter two with dhcpd, the DHCP server). Although all four work properly on many networks, some networks use DHCP servers that don't get along well with one or another Linux DHCP clients. You might therefore need to replace your DHCP client package with another one.
• Incompatible DHCP options— DHCP client options sometimes cause problems. In practice, this situation can be difficult to distinguish from an incompatible DHCP client, but the solution is less radical: You can edit the DHCP startup script to change its options. Unfortunately, you'll need to learn enough about your DHCP client to have some idea of what options to edit. Reading the man page may give you some ideas.
• Multi-NIC configurations— If your computer has two or more network interface cards (NICs), you may need to get the DHCP client to obtain an IP address for only some cards, or to disregard some information (such as the gateway address, described in more detail shortly in "Adjusting the Routing Table") for some NICs. Again, editing the DHCP client startup script may be necessary, or you may need to create a custom script to correct an automatic configuration after the fact.